Boomstick Arms 

Boomstick Arms Co. LLC

North Texas Gunsmithing and Machining

Colt and Clot Clones

Service Descriptions

Premium  Action Job

The receiver of the pistol is polished and deburred. All moving parts are polished for a smoother action. Then the springs are tuned and the timing is adjusted accordingly.

Open Rear Sights

The rear sight is machined out using a mill, this helps your eyes focus on the front sight.

Bead Blasting

Bead blasting is the process of dulling the surface to a matte finish by applying fine glass beads or sand at a high pressure.

Jeweling

Jeweling, what is shown on the hammer and trigger in the picture above, is a finish that can be applied to almost any gun.

Cut Barrel and Ejector Rod Housing

The barrel is cut to preferred length. If the length is under 4 5/8 in. the ejector rod and housing will be trimmed to fit. Sights are available upon request.  

Brass Sights

Old sights are removed, brass sights are machined and installed.

Fit Grip Frame

Grip frames are fitted and polished to pistol.

Spur Conversion

Spurs are cut off and welded to your hammers. They are polished to a seamless finish.

Octagon Barrels

Barrels are made from barrel blanks, they are cut down to your preferred length and threaded to fit your pistol. The barrels are machined into their octagon shape. They are then polished, crowned, and their forcing cones are polished. The ejector rod housing is installed. If the length of the barrels are less than 4 5/8 in. then the ejector rod housing is fitted. The barrels are then adjusted to the cylinders and new brass sights are installed.


Adjust Spur Angle

Spurs are heated and bent to preferred angle. Then polished.